Why is my dishwasher not draining?
A dishwasher that leaves water in the tub almost always has a blockage or a failed drain pump. The filter under the lower spray arm traps food, and in many homes it has never been cleaned.
- Clogged filter: twist out the cylinder filter and rinse it under hot water.
- Blocked drain hose or air gap: a kink behind the unit or a clogged air gap on the sink stops drainage.
- Garbage disposal plug: new disposals ship with a knockout plug that must be removed.
- Failed drain pump: you hear a hum but no water moves. This part needs replacement.
Why are my dishes still dirty after a cycle?
Poor cleaning comes from low water temperature, blocked spray arms or a weak circulation pump. Dishwashers clean best with incoming water at 120°F, so run the kitchen tap until it is hot before you start a cycle.
- Spray arm holes clogged with hard water scale or seeds
- Failed heating element, which also leaves dishes wet
- Worn circulation pump or wash motor
- Detergent dispenser door not opening
Why is my dishwasher leaking?
Leaks from the door usually come from a worn door gasket or the wrong detergent creating suds. Leaks under the unit come from the water inlet valve, the drain hose connection or a cracked pump housing. Turn off the supply valve under the sink until the leak is fixed.
Why won't my dishwasher start?
Check the child lock first, then the door latch. A dishwasher will not run unless the latch switch confirms the door is closed. Other causes include a blown thermal fuse, a failed touchpad and a faulty control board.
Five checks to do before you call
- Clean the filter under the lower spray arm.
- Confirm the breaker is on and the child lock is off.
- Run hot water at the sink for 30 seconds before starting.
- Make sure the drain hose under the sink is not kinked.
- Use only dishwasher detergent. Dish soap creates foam that leaks.
Bosch dishwasher repair in Rochester
Bosch is one of the most common dishwashers in Rochester kitchens. Its frequent faults include the E15 code, which means water has reached the base pan and tripped the float switch, and the E24 or E25 codes, which point to a drain blockage or pump issue. Do not tilt a Bosch to clear E15 until the leak source is found, or it will return.
We also repair Whirlpool, KitchenAid, GE, GE Profile, Samsung, LG, Maytag, Frigidaire and Miele dishwashers.
Dishwasher installation service
A correct installation prevents most early leaks. Our installers connect the supply line, route the drain with a high loop or air gap, wire the unit to code, level it and secure it to the countertop. We can haul away the old dishwasher on the same visit.
Dishwasher repair questions
Why is there standing water in the bottom of my dishwasher?
A clogged filter, a blocked drain hose or air gap, or a failed drain pump causes standing water. If you recently installed a garbage disposal, the knockout plug in the disposal inlet may still be in place.
How long does a dishwasher last?
A dishwasher lasts about 9 to 10 years on average. Bosch and Miele models often run longer with regular filter cleaning.
Do you install new dishwashers?
Yes. We install built in dishwashers, connect the water supply, drain line and electrical, level the unit, secure it to the countertop and run a test cycle to check for leaks.
Is it safe to run a dishwasher that is leaking?
No. Water under the floor or into a cabinet can damage subfloors and cause mold. Turn off the water valve under the sink and stop using the dishwasher until it is repaired.

